18
Connecting the Crevice Nozzle / Brush Vacuum Floor
Nozzle
CAUTION!
❐
Always switch the device off
fi
rst and pull the mains plug out of the plug socket be-
fore you attach or remove any accessories.
❐
When the device is switched on and the brush nozzle is in use, the brush rotates
in the nozzle. Please ensure that the device is standing upright on a suitable
fl
oor
covering which cannot be damaged by the brush. Do not lean on the device and
do not place it on furniture or uneven surfaces. Carry the device exclusively by the
carrying handle to move it.
You can place the nozzles directly onto the device.
1. Mount the nozzles on the nozzle adapter behind the dust bin.
2. To remove the nozzles, simply pull them off.
Operation
CAUTION!
❐
Never hold the nozzles close to parts of your body or animals during use and do not
place your hands inside the nozzles. They could become stuck to the device/injured.
If the vacuum cleaner should become stuck, switch the device off immediately.
❐
Switch on the device only when you have checked that all the parts have been
properly attached and that the dust container and the dust
fi
lter are correctly inserted.
❐
If the device switches itself off during use, it is possible that the overheating pro-
tection has been triggered. Switch off the device and check the nozzle for any blo-
ckages, remove them and then allow the device to cool down for at least 15 minutes
before you switch it on again. If this does not solve the problem, contact the custo-
mer service department.
❐
On no account should the device be used to suck up the following:
–
Liquids or wet substances (e.g. wet carpet shampoo)
–
Glowing ash, cigarette ends, matches, etc.
–
In
fl
ammable or explosive substances
–
Very
fi
ne dust (e.g. concrete dust), ash or toner
–
Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are correctly attached to the device (see the "Before
Initial Use" chapter, "Inserting / Removing the Handle Pole" section and the "Con-
necting the Crevice Nozzle / Brush Vacuum Floor Nozzle" chapter).
2. Unwind the mains cable. To unwind the mains cable quickly, turn the upper cable
winder down and pull off the mains cable.
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
