25
4. Press the button to open the dust container. The bottom of the dust container will
open and the dirt will fall out.
5. Shut the dust container bottom again. The fastener must audibly lock into place.
6. Put the dust container in the device: Take it by the handle and insert it bottom
fi
rst
into the device. Then push the handle towards the device housing until the dust
container audibly clicks into place. Hold the device by the dust container handle and
lift it up to check that the dust container is correctly locked into place.
Cleaning the cyclone insert and motor
fi
lters
The cyclone insert is situated inside the dust container. The motor
fi
lters are situated in
the
fi
lter holder on the cyclone insert.
1. Remove the dust container from the device and empty it (see section “Emptying the
dust container”).
2. Turn the lid of the dust container as far as it will go in an anticlockwise direction.
Remove the lid.
3. Carefully remove the cyclone insert (
B
) from the dust
container.
4. Pull the
fi
lter holder (
C
) out of the cyclone insert and
remove the foam
fi
lter.
Please note: The second motor
fi
lter is attached to the
fi
lter holder and cannot be removed from the holder!
5. Tap out all the parts over a bin and brush away any loose
dirt.
6. If required, rinse out the
fi
lters thoroughly with clear, lukewarm water.
Attention
: Do not use any cleaning products!
Next shake off any surplus water and leave the
fi
lters to air dry completely before
replacing them in the device.
7. You can clean the cyclone insert and dust container with a damp cloth.
8. When all parts are dry, replace the cyclone insert in the dust container.
Please note: There is an arrow symbol on the top of the cyclone insert. Place the
cyclone insert into the dust container so that this arrow symbol points to the
symbol on the dust container.
9. After drying, place the foam
fi
lter back into the
fi
lter holder and replace the holder
onto the cyclone insert.
Attention
: Never put damp parts back into the dust container!
10. Put the lid on the dust container so that the arrow symbol on the lid points to the
symbol on the dust container. Close the lid by turning it as far as it will go. The arrow
symbol should now be pointing to the symbol on the dust container.
11. Put the dust container in the device. Make sure that it audibly locks into place.
If the
fi
lters are damaged or worn you can order new
fi
lters at
www.service-shopping.de
.
C
B
