EN
20
Attaching / Removing Nozzles
• Plug the free end of the telescopic tube as far as it will go into one of the nozzles
supplied. Twist the nozzle back and forth slightly as you do this.
• For
greater
fl
exibility, the nozzles can also be plugged directly onto the handle of the
suction hose, without the telescopic tube.
• To detach a nozzle, pull it off.
Operation
PLEASE NOTE!
■
Only switch on the vacuum cleaner once all parts have been completely mounted and
all
fi
lters have been inserted correctly.
■
Note the
MAX
marking on the dust container. If during use the marking is reached,
empty the dust container. The
fi
lters must also be regularly cleaned in order to pre-
vent overloading of the motor.
■
To ensure that the mains cable does not become hot during operation, pull out at
least two thirds of the total length from the device before the vacuum cleaner is
switched on. Do not pull out the mains cable with force up to its maximum length (not
further than the red marking on the mains cable) in order to prevent damage!
1. Attach the nozzle you want to the telescopic tube or suction hose (see the “Assembly”
chapter – “Attaching / Removing Nozzles”).
2. Pull the mains connecting cable out of the housing, ideally up to the yellow marking,
but not further than the red marking on the mains connecting cable!
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Press the On / Off switch to switch on the vacuum cleaner.
5. The suction force can be reduced or increased by turning the On / Off switch to-
wards
MIN
or
MAX
.
6. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
Tip:
The handle is equipped with an exhaust air valve. Open
the exhaust air valve (by sliding the cover) to further reduce
the suction force when cleaning upholstery, rugs or light,
movable objects.
Normally the exhaust air valve should be closed to prevent
the unnecessary reduction of the suction force.
7. After vacuuming, press the On / Off switch to switch off the device.
8. Pull the mains plug out of the plug socket, hold the mains connecting cable securely
and press the
button for winding up the cable with your foot. Holding the mains
connecting cable prevents any "whiplash" effect of the cable, e.g. against your legs.
9. To ensure optimum performance of the device, empty the dust container after every
use.
