EN
20
Cleaning and storing the device
ATTENTION!
■
Before you clean the device, always pull the mains plug out of the socket.
■
Keep the motor unit (
2
), the mains cord (
E
) and the mains plug away from water or
other liquids to prevent electrical shocks. Always take the dust bin (
1
) off of the motor
unit (
2
) before cleaning.
■
Accessories that are cleaned with water must be completely dry when inserting them
in the device!
■
The
fi
lters are not suitable for the washing machine, dishwasher or dryer. Only air dry
the
fi
lters; do not in any case use a hair dryer!
■
Do not use any sharp or abrasive cleaners or cleaning pads. They could damage the
surfaces.
The
fi
lters may discolour over time. This is normal and does not affect the func-
tionality.
If the
fi
lters are damaged or worn, new
fi
lters can be ordered via
www.service-shopping.de
.
Emptying the dust bin
1. Push the release button (
A
) for the dust bin. Take the dust
bin (
1
) off of the motor unit (
2
).
2. Hold the dust bin (
1
) over an open rubbish bin. The dis-
tance to the rubbish bin should be as small as possible so
that the dust does not disperse in the surroundings.
3. Pull the latch on the bottom hatch (
G
) down. The bottom
hatch (
F
) will open and the dirt will fall out.
4. Close the bottom hatch (
F
). The fastener must audibly lock
into place.
Cleaning the
fi
lters
1. Empty the dust bin (
1
) (see above).
2. Turn the lid of the dust bin (
J
) slightly anticlockwise and
then lift it off.
3. Take the
fi
lter holder (
K
) off of the cyclone insert (
H
).
4. Pull the foam
fi
lter (
L
) out of the
fi
lter
holder (
K
).
The
fl
eece
fi
lter is secure-
ly attached to the
fi
lter holder
(
K
)
and cannot be removed!
5. Carefully take the cyclone insert (
H
) out of the dust bin (
1
).
6. Knock all parts out over a rubbish bin and brush them off
if necessary. Rinse them off with clean water if necessary.
ATTENTION:
Do not use any detergent!
Then
let them dry completely. Do not assemble when
wet or damp!
J
K
H
1
K
L
