CleanMax CMP-3N, Operating Instructions Manual

Page: 8 / 16

6
How to Assemble and Operate the Vacuum
How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1. Remove the handle screw, insert handle into the hole on top of
the vacuum cleaner (Fig. 1).
2. Line up the small hole on the handle with the small hole on the
vacuum cleaner, and insert the screw. Make sure the screw is
tightened securely.
How to Attach the Extension Power Cord to the Cord Lock
1. Connect the extension power cord to the pigtail cord on
the vacuum.
2. Snap the extension power cord into the slot on the end of the
cord lock.
3. Turn the knob on the bottom of the cord lock to tighten the
lock and prevent the cords from pulling apart (Fig. 2).
How to Attach the Cord to the Retainer Hook on the Handle
1. Create a loop in the power cord, and push it through the slot
and over the hook of the cord retainer (Fig. 3).
2. Pull down on the power cord to remove any slack (Fig. 4).
On/Off Switch
1. To turn the vacuum on, push the switch located on the dust
compartment to the ( I ) position (Fig. 5).
2. To turn the vacuum off, push the switch located on the dust
compartment on the ( 0 ) position.
Full Bag Indicator
(Model CMP-3QD)
The full bag indicator is designed to show when the bag is full or
when there is a clog in the vacuum. (Fig. 5).
1. If the indicator light illuminates, change the vacuum bag. If the
bag isn’t full, check the hose for a clog.
2. When cleaning with a tool, the indicator light may illuminate. In
this case, continue cleaning.
Fig. 1
Fig. 4
Fig. 2 Fig. 3
Fig. 5