background image

2

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, 
including the following:

READ ALL INSTRUCTIONS BEFORE 

USING THIS APPLIANCE

      

 

 

The manufacturer cannot accept responsibility for damage 
caused when the appliance is not used according to the 
instructions, or for uses other than those for which it was 
intended. 

WARNING:

 To reduce the risk of fire, electric shock or injury:

IMPORTANT:

•  Do not leave appliance when plugged in. 

Unplug from outlet when not in use and 
before servicing.

•  Do not use outdoors or on wet surfaces.

•  Do not allow to be used as a toy. Close 

attention is necessary when used by or 
near children.

•  Use only as described in this manual. 

•  Do not use with damaged cord or plug. If 

appliance is not working as it should, has 
been dropped, damaged, left outdoors, or 
dropped into water, return it to the distributor 
where purchased for service. 

•  Do not pull or carry by cord, use cord as a 

handle, close a door on the cord, or pull cord 
around sharp edges or corners.  Do not run 
appliance over cord. Keep cord away from 
heated surfaces.  

•  Do not unplug by pulling on cord. To unplug, 

grasp the plug, not the cord.

•  Do not handle plug or appliance with 

wet hands.

•  Do not put any object into openings. Do not 

use with any opening blocked; keep free of 
dust, lint, hair and anything that may reduce 
air flow. 

•  Keep hair, loose clothing, fingers and all 

parts of body away from openings and 
moving parts. 

•  Do not pick up anything that is burning or 

smoking, such as cigarettes, matches or 
hot ashes.

•   Do not use without vacuum bag in place.

• Turn off all controls before unplugging. 

• Use extra care when cleaning on stairs. 

•  Do not use to pick up flammable or 

combustible liquids such as gasoline  
or use in areas where they may be present. 

•  Do not attempt to service the unit while 

appliance is plugged in.

•  Connect to a properly grounded outlet only. 

See Grounding Instructions.

•  Make sure your extension cord is in good 

condition and is the correct size for your 
appliance, i.e. 16 AWG. If in doubt, use the 
next heavier gage. The smaller the gage 
number, the heavier the cord. An undersized 
extension cord will cause a drop in line 
voltage resulting in loss of power and 
overheating.

•  Use only three-wire outdoor extension cords 

that have three-prong grounding plugs and 
grounding receptacles that accept the 
appliance’s plug.

•  Warning - To reduce the risk of personal 

injury due to a loose electrical connection 
between the appliance’s plug and extension 
cord, firmly and fully attach the appliance 
plug to the extension cord. Periodically check 
the connection while operating to ensure it is 
fully attached. Do not use an extension cord 
that provides a loose connection. A loose 
connection may result in overheating, fire, 
and increases the risk of a burning.

•  To reduce the risk of disconnection of the 

appliance cord from the extension cord 
during operating, secure the extension cord 
to the appliance plug as shown or described 
in the Operating Instructions

SAVE THESE INSTRUCTIONS.

Summary of Contents for CMP-3N

















Reviews: