Rinsing the water lines
Description of the rinse function:
Use the switch (A) to select the hall program function.
Start the Robo 40 as described in the "Starting the Robo 40" chapter.
As soon as the "run" and "Start/Stop" lamps are lit permanently, the pump function can be started by
pressing and holding the "run" button (B).
Rinse the water lines for 5 to 10 seconds before each use of the Robo 40. After completion of the rinsing
process, check the water discharge on the ground. This guarantees an intact water flow.
Clogged water line or brush strip:
If no water flows, repeat the procedure 2 to 3 times. If there is still no water flowing, the water line can be
rinsed and cleaned with a concentrated cleaner. To do this, put the suction filter directly into a container
filled with approx. 1 L of cleaning solution (C).
If there is still no water flowing through the water distribution brush even after cleaning the water line, then
call the service hotline.
Charging the batteries
After cleaning, the Robo 40 can be connected to the charging station (1). To do this, remove the dirty water
tank and connect the charging cable to the socket (2) of the Robo 40.
Pressing the emergency stop button
Only press the emergency stop button in emergencies or to transport the unit when it is "on".
After completion of cleaning, switch off the unit only with the on/off button.
If this is not observed, damage may occur to the roller brushes because they are not raised from the floor.
- MISCELLANEOUS -
1
2
A
C
3
A
B
