cleanAIR AerGO NA-041-R01, User Manual

Page: 6 / 152

6
________________________________________________________________________________
4
6.2. BATTERY
IMPORTANT! Batteries are supplied uncharged. Always charge the battery before the first use.
The battery charger is not designed for use outside – only use in an environment protected from rain and
moisture. Do not charge the battery in a potentially explosive atmosphere. Using the battery charge for purposes
other than those specified by the manufacturer is forbidden.
6.2.1. Battery charging
1. Check that the mains voltage is suitable for the battery charger.
2. Plug the charger into the mains – the red LED will start blinking.
3. Connect the battery to the charger. The charging connector is at the rear of the battery. The red LED will light
up and remain lit to indicate that the battery is charging.
4. After charging, first disconnect the battery and then unplug the charger from the mains. The green LED will
light to indicate that charging has finished and that it has switched over to maintenance mode.
Always unplug the charger from the mains once charging is finished!
6.2.2. Battery replacement
Grip the filtration unit by both hands with the battery facing up and the rear away from you. With one thumb
release the latch holding the battery in the lock position and at the same time take the battery out of the unit
body with your other hand.
Battery installation
Steadily reinsert the battery into the unit body until the battery is locked in place by the latch.
(see pictorial supplements 3A, 3B)
6.3. Belt replacement
The CleanAIR AerGO® system is equipped with a mechanism allowing you to replace the belt easily and
quickly.
Bend the belt at the joint to its limit position (towards the rear of the unit) until the locking mechanism is exposed.
After releasing the lock (by pulling outwards from the unit), you can remove the belt freely. Repeat the same
procedure for the other half of the belt.
When installing a new belt, simply push the belt axis into the clamping mechanism of the unit until it is locked by
the latch. Repeat the same procedure for the other half of the belt.
Caution! You cannot interchange the belt sides!
(see pictorial supplements 4A, 4B)