8
PANIFY
Switching on the fixture
- Fig. 8
Switch-on the fixture. The fixture starts resetting the effects. At the same time, the following information scrolls on the display:
Panify Dmx Address xxx
The control panel (Fig. 8) has a display and buttons for the complete programming and management of the fixture menu. The display can be in one of
two conditions: rest status and setting status. When it is in the rest status, the display shows the fixture’s DMX address.
During menu setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns to rest status.
It should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the
F
key will be cancelled.
1
Dmx Address
8
3.4 Switching on the fixture and basic SetUp
28
28
Reversal of the display
- Fig. 9
To activate this function, press UP
B
and DOWN
C
keys simultaneously while the display is in the rest mode. This status will be memorised and
maintained even for the next time it will be switched on. To return to the initial state, repeat the operation all over again.
Setting the fixture starting address
On each fixture, the starting address must be set for the control signal (addresses from 1 to 512).
The address can also be set with the fixture switched off.
9
