17
SCENIUS SPOT
MANUAL CONTROL
LAMP
It lets you turn the lamp on (ON) or off (OFF) from the projector control panel.
RESET
It lets you reset the projector from the projector control panel.
CHANNEL
It lets you set the channel DMX levels from the projector control panel (value between 0 and 255 bit or between 0% and
100%).
TEST MENU
It lets you test the correct operations of effects using saved Tests.
ADVANCED MENU
To open the “Advanced Menu”, enter the code (1234)
UP LOAD FIRMWARE
It lets you transfer "firmware" from one projector to all other connected projectors. A confirmation message appears on
the display (Are you sure ?) Select YES to confirm or NO to abort this operation.
SETUP MODEL
It lets you change the projector model (operation probably necessary after replacing the CPU during repairs). A
confirmation message (Are you sure ?) appears on the display Select YES to confirm (the list of available and selectable
projectors appears) or NO to abort this operation.
CALIBRATION
It lets you make small mechanical adjustments on some effects to perfectly align projectors from the control panel.
Factory default
It lets you restore default "Calibration” values (128 bit) on all channels.
ROT GOBO INDEXING
It lets you run the rotating gobo wheel gobo indexing procedure. This operation may be necessary after projector
maintenance/cleaning.
MENU LOCKING
It allows you to assign a password to lock the access to the user menu, so that only users know the password can change
settings. The password is 4-digit number.
