Clavia nord lead, Owner'S Manual

Page: 29 / 114

Programming Velocity Sensitivity Page 27
Moving the Range
As explained above, step 1 to 4 sets the range of the parameter, how far it should be between the mini-
mum and maximum values.
If you then turn a knob that has been programmed for velocity sensitivity, without holding any buttons
or anything, you will adjust the minimum value only and the maximum value will move with it, accord-
ingly.
Clearing Velocity Programming For One Knob
1. Turn the knob to its lowest value.
2. Press the Velocity/Morph button.
3. Turn the knob a bit up and then back to its lowest value.
4. Press the Velocity/Morph button again.
The Velocity/Morph function is now cleared for the knob.
5. Turn the knob back up to any desired value.
When velocity programming is cleared for all knobs, the Velocity/Morph LED goes out.
Clearing All Velocity Programming
To clear all velocity programming, press the Clear button in the Velocity/Morph section.
Pulse width
p o l y p h o n i c
Pulse width
p o l y p h
If you adjust the value for a parameter programmed for velocity control,
you move the entire velocity control range up/down:
This minimum value
This minimum val-
ue will result in this
maximum value.
will result in this
maximum value.