15
METRONOME
Press the METRONOME button; the built-in metronome will start to play with the current
tempo and beat pattern. If press the METRONOME button and
▲
or
▼
button
simultaneously, the metronome is engaged as well the display shows the current beat
pattern (the default setting is 4/4). There is a doc between the number of beat per
measure and the note definition of note. e.g. the picture below refers to 3/4. Use the
▲
,
▼
button to change the beat pattern in sequence of 1/4, 2/4, 3/4, 4/4, 5/4, 6/4, 6/8 and 12/8.
When the metronome sounds, the beat indicator will flash per the beat pattern.
Press any button except
▲▼
, or after finish the selection or not manipulate for 3 second,
the display shows the master voice and return to the voice select mode. The Metronome
indicator keeps on.
Press the METRONOME button again to stop the metronome.
Note
: Reverb and chorus sound effect does not apply to the metronome sound.
TEMPO
Press the TEMPO button to enter the tempo setting mode and its indicator blinks. The
display shows current tempo value (the default is 120) followed by a dot mark. Use the
▲
,
▼
button to change the tempo ranged 40 – 240; press
▲
and
▼
buttons
simultaneously to recall the default tempo 120. If you press and hold down the
▲
or
▼
button, the tempo will change continuously until release the button. Press any button
except
▲▼
, or after finish the setting or not manipulate for 3 second, the display shows
master voice and return to the voice select mode.
METRONOME
TEMPO
TEMPO
