Classeq D 400, User Manual

Page: 17 / 224

Classeq Under Counter Range - User Manual
11
UK
G¾” (¾” BSP) male threaded connection at the mains water
outlet.
Warning!
Use only the hose supplied with your
warewasher to connect it to the water supply.
Old existing, defective or damaged water supply
hoses
MUST NOT be used.
Connect the 90 degree bend connector of the water supply hose
to the inlet on the back of your warewasher and the straight
connector to the mains water supply.

Ensure the rubber seals are in place in the connectors.
 Hand tighten the connectors only.

Ensure all connections are watertight before using your
warewasher.
4.6 Waste Water and Connection
4.6.1 Waste water system type
The waste system of your warewasher will vary depending on the
variant. You can identify the type of drain your warewasher has
by checking whether there is a Drain Plug, as shown, present in
the Wash Sump.
Warewashers with a Drain Plug are gravity drain type and
warewashers without a Drain Plug are pumped drain type.
4.6.2 Waste water connection
Gravity drain warewashers:
If your warewasher has a Drain Plug fitted in the Wash Sump the
waste hose will fit into Ø40mm plumbing or over a Ø20mm
spigot.
The waste hose for this type of warewasher has to lead away
below the base of the warewasher.
Pumped drain warewashers:
The outlet end of the waste hose of a pumped drain type
warewasher can be trimmed to fit a variety of sizes of pipes /
spigots.
The waste plumbing for this type of warewasher can be up to a
maximum of the following heights from the base of the
warewasher:
Warewasher size Max waste height (mm)
G350 420
(D400/G400) 540
(D500/G500) 600
Fit the waste hose of your warewasher to the existing waste
piping. Ensure that the waste hose is not kinked. Ensure that the
waste hose is fitted in such a way that it will not come off or out
of the existing waste piping during warewasher operation.
Maximum drain
stand pipe height
Max Waste
Height