Page 5
4.2 Rinse & wash tank temperatures :
To ensure NSF compliance, the water temperatures on ’
Classeq
’
range of appliances must be set to
the following.
Machine type
Temperatures (minimum)
Rinse water
Wash water
180ºF (82°c)
150ºF (66°c)
C200G, C300G, C500U, C750U & C850P
4.3 Machine ready status :
All the appliances are designed to allow a cycle to commence once the wash tank and rinse boiler
are full, not taking into account the temperature of their associated water.
To ensure NSF compliance, the temperatures must be set as stated in section 4.2 of this manual
and the ‘Machine ’GREEN ’ lamp is illuminated, then and then only should a cycle be selected.
To adjust the amount of chemical, rotate the centre dial on the timers , the timers are located
C200G, C500U, C300G and C750U
- Under the top panel of the appliance.
C850P
- Behind the front lower panel on the control panel
Machine sizes
Rinse aid
Cycle
Deter-
gent
Cycle
C200G
5
10
C300G
5
10
C500U
5
10
C750U
5
10
C850P
5
10
Pre-set values
(in seconds)
4.4 Demonstration :
‘
Classeq’
recommends that prior to leaving the site / installation, the installer demonstrates the
following to the end user, as this will ensure the appliance is correctly used
•
What to do in case of an emergency, i.e. how to turn the appliance off at the source
(see
section 1).
•
Switching the appliance on.
•
Operating the appliance.
•
Draining down.
•
Switch the appliance off.
•
Clean the appliance, including removal and replacement of all filters.
•
Replenishing and priming of rinse aid and detergent.
Upon completion of the installation and commissioning of the appliance, this manual
MUST
be left
with the end user.
