11
SA-30
CONTROLS
DEPTH SET (J1 & J2)
- The depth setting is
located below and to the rear of the engine on each
side. Place the pin in the hole on each side for the
depth you wish to aerate. NOTE: Actual depth may
vary depending on soil conditions, tire pressure and
tine wear.
FUEL VALVE (K)
- The fuel valve is located
behind the fuel tank on the right side of the machine.
the fuel valve is open when the knob is in-line with
the fuel line hose. Close the valve by turning the
knob a quarter turn to be perpendicular to the fuel
line hose.
JACK STANDS (L1 & L2)
- Built-in jack stands
allow servicing the chains and the tine assembly
without moving the machine. To put the machine
"UP" on the jacks, lower the tines on a hard surface
to raise the machine. Pull the pin
(L2)
on each jack
(L1)
and drop it. Put the pin back in the upper hole
of the jack to secure it. Raise the tines to set the
machine on the jacks.
To lower UNIT, lower tines, pull pin from upper hole,
raise up jack, and re-insert pin to secure jacks.
Raise tines to place unit on ground.
