CLAS PE 2011T, Manual

Page: 15 / 32

PE 2011T
2 COLUMNS POST LIFT 400V 6T HIGH PASSAGE
4480mm 2.6Kw
15
PACKING
Discharge the outside packing and other packing material, to check whether any damage or
missing during transportation according to “packing list”. If find damage or missing, should notice
the carrier immediately.
DESCRIPTION OF MACHINE
This two post lift can lift various vehicles which weight is less than 6000kg. And it is suitable for
vehicle test, repair, maintenance and care.
This lift is designed to lift vehicles, not for other usage.
• Forbid to use for washing and spraying vehicles!
• Forbid to lift vehicle which weight is over 6000KG!
FEATURES
• Design and manufacture according to relevant standard, and machine performs stable and
reliable.
• With hydraulic locking and mechanical locking system, safety and reliable.
• With insurance bar for top protection, to prevent effectively the vehicle from being damaged.
• With safety valve and antiknock valve in case of hydraulic failure or over loading, to prevent the
lift from lowering quickly when oil pipe bursts.
• Double cylinder drive, to lift and lower stably.
• Adopt imported hydraulic and electrical components from Italy, Germany and Japan.
MAIN FABRIC PRINCIPLE
• Lifting fabric: Each post has one cylinder, when pump the oil into the cylinder, the cylinder pole
will move upwards, to hold the carriage move upwards.
• Support fabric: After driving the vehicle into the working area, adjust the angle of arms and
length of extension arms, to ensure the arms support on the effective vehicle bearing point.
Fix the position of vehicle by arm orientation fabric, in case of slipping.
Then adjust the screw to fit different height chassis.
• Balance fabric: To keep the balance during lifting, connect the two carriages with piston pole of
the two cylinders to adjust hydraulic oil make two carriage ensure the synchronization.
If carriages, arms are not in level, adjust hydraulic oil of the cylinder, to ensure the carriages and
arms in level.
• Electromagnetic safety locking fabric: During lifting, each post has safety-locking device to
ensure the lift can stop reliable without falling.
• Principal of electromagnetic safety locking: The upper side of safety racks adhibit on the safety
teeth for the angle and deadweight. The carriages push the safety rack and go up step by step. If
failure of lift and begins to lower quickly, safety rack will clip on the teeth to stop the carriage to
stop lowering. (See picture 9 and 10)
• There are orientation device on the arms, to lock arms when they are in proper position, which
can prevent the vehicle from slipping.