4
English
Installation
Transmitter
1. Connect the DC plug from the mains adapter.
2. Connect the adapter to a wall socket. The Power LED lights up.
3. Connect the desired sound source, eg TV, DVD, radio, CD, MP3 player, etc.
The Signal LED is lit when the transmitter has an input signal.
Receivers (loudspeakers)
Powered by batteries (A) or mains adapter (B).
A.
Remove the cover from the battery compartment.
Install six AA/LR6 batteries in accordance with the markings in the battery compartment
and refit the cover.
B.
Connect the DC plug from the supplied 9 V adapters to each loudspeaker.
Use
1. Switch on the sound source that is connected to the transmitter. The Signal LED (2) lights up.
2. Set the required channel with [Channel 1 – 2] (4) on the transmitter. Choose the channel
with the least interference.
Choose the required function on both loudspeakers with the function selector switch [
L
/
M
/
R
] (11)
Stereo:
Set on loudspeaker to left (
L
) and one to right (
R
).
Mono:
Set both loudspeakers to
M
.
3. Switch the loudspeakers on/off: Press and hold [
] (8) and [
] (6) at the same time.
4. Press [Auto Scan] (10) for to obtain optimum reception. Frequency scanning starts,
and stops when a signal is found. The LED indicator (7) shows green when a good signal
has been found. Set the required loudspeaker volume with [
] (8) and [
] (6).
5. When the frequency is occupied: Choose another channel on the transmitter,
then press [Auto Scan] (10) again.
6. Press [Bass Boost] (9) to increase/reduce the bass boost.
NOTE:
If the transmitter is switched off or if there is no input signal to the transmitter,
the LED changes colour from green to blue after about four minutes.
If there is no input signal to the transmitter (or if it is very weak) the LED (2) on the transmitter goes
out after about four minutes. When the input signal returns, the transmitter starts automatically.
Positioning:
Position the loudspeakers on a completely smooth surface. Avoid placing them in a depression
or in grass.
