6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Never exceed the maximum operating pressure for the tool. It is
recommended that air pressure does not exceed 90 psi at the tool when
running. Higher pressures and unclean air will shorten the life of any air tool
due to faster wear and is a possible safety hazard.
Use only clean, dry, regulated compressed air as a power source.
Air compressors used must comply with the appropriate European Community
Safety Directives.
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the air tools used. Ensure any moisture is drained from the
compressor daily and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased.
The air hose must be rated at least 150% of the maximum operating pressure of
the drill.
OVERVIEW
1
Chuck
5
Air Exhaust Deflector
2
Trigger 6
Male
inlet
connector
3
1/4” BSP female air inlet
7
Chuck Key
4
Speed Selector Switch
Summary of Contents for X-Pro CAT207
Page 16: ......
