4. Adjusting 90 and 45 Degree Positive Stops
4A. Adjusting Positive Stop at 90 Degrees
1.
Raise the blade to maximum height.
2.
Loosen the blade tilt locking handle and push the height adjuster wheel to the left as far as
possible. Holding in this position, retighten the blade tilt locking handle.
3.
Place a combination square on the table
with one end of the square against the
blade as shown (Fig.27),and check to see
if the blade is at 90
O
4.
if It is not at 90
O
to the table, loosen the
blade tilt locking handle, then slacken off
the 90
O
stop screw (A) a few turns, (i.e. turn
anticlockwise). Push the blade height
adjuster wheel until the blade is exactly 90
O
to the table, checking with the square,
then retighten the blade tilt locking handle,
taking care not to move the blade.
Double check the 90
O
angle after
retightening.
5.
Screw in the 90
O
stop screw (A) until you
Fig.27
can feel it butting up against the stop.
6.
Recheck by slackening the Blade tilt locking handle allowing the blade to be moved to an
upright position, then bringing it up against the stop once again, retightening the locking
handle and rechecking the blade angle with the square. If it is not exactly 90
O
carry out the
adjustment again until satisfied.
Finally zero the pointer.
4B. Adjusting Positive Stop at 45 Degrees.
1.
Loosen the blade tilt locking handle and
push elevation wheel to the right as far as
possible. Holding in this position retighten
the blade tilt locking handle.
2. Check to ensure the blade Is exactly 45
O
to the table, using a 45
O
angle gauge. If
necessary proceed to adjust using the
method described above, using the stop
screw (B), as shown in fig. 2B.
CAUTION!
DO NOT attempt to perform’non-through type’ cuts on this machine, as it should NOT
be used with the Riving Knife or Blade Guard removed.
2
Fig.28
Summary of Contents for Woodworker CTS10PLM
Page 28: ...PARTS DIAGRAM...
Page 30: ...PARTS DIAGRAM Motor and Blade Adjuster Components...
