9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
In addition to the assembly procedures below, some disassembly is required to
remove storage grease and re-lubricate the cleaned parts.
TO ASSEMBLE YOUR MACHINE:
1. Remove the end cap screws from
the end cap.
2. Rotate the lock knob out until it is
flush with the rear of the end cap.
3. Insert the hand crank into the slot
(see Figure 7).
4. Replace the end cap and cap
screws and tighten the lock knob.
NOTE:
It is your preference which
side of the machine you install the hand crank.
5. Thread the rods into either the
brake or sheer mounting holes, as
shown in Figure 8. Only hand-
tighten the rods.
6. Loosen the hex bolts on the stop
bar and slide it onto the rods.
7. Position the stop bar as required
and secure using the hex bolts as
shown in Figure 9.
Fig. 7
Fig. 8
Fig. 9
Summary of Contents for SBR760
Page 36: ......
