24
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SERVICE
SHEARING BLADE REVERSAL/REPLACEMENT
The shearing blades are reversible, so when the first cutting edge becomes
dull, the blades can be rotated to use the second cutting edge.
When both cutting edges of the blade become dull, use wet grinding
techniques for SK-4 metal or better to sharpen the cutting face of the blade.
The upper shearing blade uses a 5° relief edge and the lower table blade
does not. However, if you are not comfortable performing the sharpening
procedure or do not have access to a professional sharpening service,
replacement blades are available through the Clarke spares department.
Tools Needed
TO REVERSE OR REPLACE THE SHEARING BLADES:
1. Remove the hex bolts and springs
that secure the shear holddown
bar (see Figure 42).
2. Remove the six cap screws that
secure the blade, then carefully
remove it from the machine (see
Figure 43).
Tip:
When removing or installing the
upper shear blade, remove the cap
screw at one end, then insert a small
hex wrench or similar tool through the
Tools Needed
Qty
Wrench or Socket 10 mm
1
Hex Wrench 5mm
1
CAUTION: THE SHEARING
BLADES ARE SHARP AND CAN
QUICKLY CUT YOUR HANDS.
ALWAYS WEAR HEAVY LEATHER
GLOVES WHEN HANDLING THE
SHEARING BLADES TO AVOID
THIS CUTTING HAZARD.
Fig. 42
Fig. 43
Summary of Contents for SBR760
Page 36: ......
