22
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7. Place a thin piece of wood on the
finger receiver, as shown in Figure
36, then reinstall the fingers so that
they rest on the wood. Make sure
the tops of the fingers are
between the gib and the casting.
NOTE:
Install the widest finger to the
right, then repeat with each
smaller finger.
8. Make sure the fingers are slightly
loose between the gib and the
casting, then use the hand crank
to raise the receiver to fully seat
the fingers up against the casting
behind the gib, as shown in Figure
37.
9. Re-tighten all of the gib cap
screws.
GEARS
Clean away grease and built-up
grime from the top and bottom roller
gear teeth, as shown in Figure 38,
with a stiff brush and degreasing
spirits.
When dry, apply a small amount of
grease to the teeth, then use the
hand crank to rotate the rollers and
distribute the lubricant.
HAND CRANK BUSHINGS
Wipe off the grease fittings next to
each hand crank hub (see Figure 39),
then use a grease gun to add a small
amount of multi-purpose grease to
the hand crank bushings.
Fig. 36
Fig. 37
Fig. 38
Fig. 39
Summary of Contents for SBR760
Page 36: ......
