17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING THE NOZZLE
if the nozzle becomes partially clogged or restricted by dirt or other foreign
material, excess pump pressure may develop. Clean the nozzle immediately by
following the instructions below.
1. Shut off the power washer and turn off the water supply.
2. Pull the trigger on the gun handle to relieve any water pressure.
3. Disconnect the spray wand from the gun.
4. Remove any obstructions and back flush with clean water.
5. Direct the water supply into the spray wand end for 30 seconds to back
flush loosened particles.
6. Reconnect the spray wand to the gun and turn on the water supply.
CLEANING THE WATER INLET
This water inlet should be checked
periodically and cleaned if
necessary.
Summary of Contents for PLS190N
Page 28: ......
