15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
APPLYING CHEMICALS AND CLEANING SOLVENTS
1. Push the chemical hose onto the
ridged fitting as shown.
2. Place the other end of the
chemical hose with the filter on it,
into a container holding the
chemical/cleaning solution.
3. Slide the nozzle forward for low
pressure operation.
• The water/chemical ratio is
typically 7:1, for every 7 gallons of water pumped 1 gallon of
chemical/ cleaning solution will be used.
SHUTTING DOWN
1. After each use, if you have applied chemicals, place the chemical hose
into a container of clean water and run clean water through the chemical
injection system to flush the system thoroughly.
NOTE:
Failure to do so could cause damage to the pump.
2. Turn the engine off. See engine owner's manual.
NOTE:
NEVER turn the water off with the engine running.
3. Turn the water supply off.
4. Pull the trigger on the spray gun to relieve any water pressure.
5. See storage section in this manual for proper storage procedures.
Summary of Contents for PLS190N
Page 28: ......
