ACCESSORIES
The following accessories are available from your
dealer. When ordering, please quote the
part number shown.
1. Quick Vise
With jaws 50mm wide, maximum opening of
37mm and 15mm deep.
‘T’ bolts with nuts and washers are provided for
mounting to the CL250M Lathe cross slide.
Part Number: 7610743
12
3. HSS End Mill (2-Fluted)
A set of 6 End Mills, of the following sizes,
for use with the Collet Set (see above)
• 3mm
• 4mm
• 5mm
• 6mm
• 8mm
• 10mm
Part Number: 7601852
2 . Collet Set (MT2)
Part Number: 7601851
A set of 6 Collets for use with the HSS End Mills:
Insert the appropriate Collet into the spindle.
Insert the the draw bolt, provided, into the
spindle, from the top and screw on to the Collet
a few turns.
Insert the appropriate Mill into the jaws of the
Collet, and tighten the draw bolt.
To remove the Collet, unscrew the draw bolt a few turns
and tap its head with a mallet to break the seal
between the Collet and spindle.
NOTE: A hole in the Spindle allows a tommy bar (not
provided) to be inserted so that the spindle may be held
whilst tightening/loosening is carried out.
Draw
Bolt
Summary of Contents for Metalworker CL251MH
Page 15: ...PARTS DIAGRAM 15 ...
Page 16: ......
