12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
NOTE:
The left hand grinding wheel locking nut has a left handed thread.
3. Slide off the grinding wheel and replace with a new one. Be sure to fit the
paper discs between the new grinding wheel and the inner and outer
retaining discs.
• Only use grinding wheels recommended by the manufacturer which
have a marked speed rating equal to or greater than the speed
marked on the rating plate of the bench grinder.
• The disc should have maximum dimensions of 150 mm diameter, 25
mm thick with a bore size of 32 mm.
• Inspect the wheel for cracks, chips or any other visible damage.
Damaged grinding wheels must be discarded.
4. Replace the outer disc with the
boss entering the grinding wheel
and trapping the paper disc.
5. Replace the nut securely.
• Do not overtighten as this may
damage the grinding wheel.
6. Re-assemble the guards fully prior
to trial running the grinding wheel.
• Each time after mounting, the
wheel should be test run for a
reasonable time (approximately 1 minute) to demonstrate true
running.
Summary of Contents for METALWORKER CHDBG500
Page 16: ......
