11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
REPLACING THE GRINDING WHEELS
1. Loosen the screws shown and
rotate and remove the cover.
2. Hold the other wheel by hand, and
remove the nut and outer flange.
NOTE:
The left hand grinding wheel
locking nut has a left handed
thread.
3. Slide off the old wheel and replace
with a new one.
• Use only wheels recommended by the manufacturer which have a
marked speed equal to or greater than the speed marked on the
nameplate of the tool
• The disc should have maximum dimensions of 150 mm diameter, 20
mm thick with a bore size of 12.7 mm.
• Inspect the wheel for cracks, chips or any other visible damage,
damaged abrasive products must be destroyed and discarded
4. Replace the outer flange.
• Make sure both wheel flanges
are placed with the concave
sides towards the wheel.
5. Replace the nut securely.
• Do not overtighten as this may
damage the grinding wheel.
6. Re-assemble the guards fully prior
to carrying out testing.
• Each time after mounting, the wheel should be test run for a
reasonable time (approximately 1 minute)..
WARNING: DO NOT USE DAMAGED GRINDING WHEELS.
WARNING: SWITCH THE GRINDER OFF AND DISCONNECT THE POWER
SUPPLY BEFORE CHANGING THE GRINDING WHEELS
CBG6250 Bench Grinder.fm Page 11 Thursday, November 10, 2011 3:26 PM
