9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
JUMP STARTING A VEHICLE (12V OR 24V)
Always carry out the following preliminary checks before connecting the
jump-start to the car battery:
• Make sure that the vehicle ignition and all ancillary equipment -
lighting, radio etc, is switched off.
• Make sure that the vehicle battery is rated at 12V or 24V and is not
damaged in any way.
• Make sure that the battery terminals are clean and the clamps are
firm and secure.
• If fitted, remove any vehicle battery filler plugs and check the
electrolyte level. If necessary, top up with distilled water.
• Make sure that the area is well ventilated.
• Take great care not to touch the red positive (+) clamp against the
black negative (-) clamp.
5. Verify the jump starter is fully charged and recharge if needed.
6. Make sure that the jumpstart is OFF.
7. Turn off the vehicle ignition switch and all accessories (lights, radio, climate
control, etc.)
8. Connect the red positive (+) clamp to the positive (+) battery terminal first.
Take care the clamp does not touch any moving parts or fuel lines.
WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE
SAFETY INSTRUCTIONS ON PAGES 3/4, MAY RESULT IN PERSONAL INJURY,
DAMAGE TO THE VEHICLE, OR THE POSSIBILITY OF A BATTERY EXPLOSION.
NEVER ATTEMPT JUMP STARTING WITH DAMAGED CABLES.
CAUTION: TO AVOID DAMAGE TO THE VEHICLE'S ELECTRICAL SYSTEM,
DO NOT USE THE JUMP STARTER ON A VEHICLE THAT HAS NO BATTERY
INSTALLED.
CAUTION: DO NOT PRESS THE OVERRIDE BUTTON IF THERE IS ANY CHARGE
PRESENT IN THE VEHICLE BATTERY. IT WOULD CAUSE PERMANENT
DAMAGE TO VEHICLES' ELECTRICAL SYSTEM.
CAUTION: DO NOT TOUCH POSTIVE AND NEGATIVE BATTERY CLAMPS
TOGETHER.
Summary of Contents for JS1224Li
Page 16: ......
