Page -6-
Clarke
®
Operator's Manual -Encore S28XP/S33XP/S38XP
PROCEDURES FOR TRANSPORTING
How To Put The Machine In A Van Or Truck
WARNING:
The machine is heavy. Make sure you use two able persons to assist
the machine in climbing the ramp.
1.
Make sure the loading ramp is at least eight (8) feet long, and strong enough to support the machine.
2.
Make sure the ramp is clean and dry.
3.
Put the ramp in position.
4.
Remove squeegee assembly, brush housings, & brushes or pad drivers before loading.
5.
Turn key switch "ON".
6.
Align the machine on a level surface ten (10) feet in front of the ramp.
7.
Put the traverse speed switch in the "HI" position.
8.
Push the control handles toward the machine all the way.
9.
Push the machine to the top of the ramp.
10. Turn the key switch "OFF".
11. Fasten the machine to the vehicle.
How To Remove The Machine From A Van Or Truck
1.
Make sure there are no obstructions in the area.
2.
Make sure the unloading ramp is at least eight (8) feet long and strong enough to support the machine.
3.
Make sure the ramp is clean and dry.
4.
Put the ramp in position.
5.
Unfasten the machine.
WARNING:
The machine is heavy. Make sure you use two able persons to assist in
moving the machine down the ramp.
6.
Turn the key switch "ON".
7.
Carefully and slowly, pull the machine to the top of the ramp.
8.
Put the traverse speed switch in the "HI" position.
9.
As the machine begins to travel down the ramp, push the control handles toward the machine to
maintain a slow downward speed.
10. Replace squeegee assembly, brush housings, & brushes or pad drivers after the machine is unloaded
and ready to use.
