Clarke
®
Operator's Manual - Encore S28XP/S33XP/S38XP
- 15 -
How to Fill The Solution Tank
CAUTION: Make sure water or solution does not
enter the opening for the vacuum motor ,See figure #19.
The solution tank lid is at the front. To fill the solution tank
follow this procedure:
1. Remove the solution tank lid. See figure #20
2. Fill the solution tank with water.
3. Add a cleaning chemical to the water. for the correct
amount, follow the directions shown on the container.
WARNING:
Water solutions or cleaning materials
used with this type of machine can leave
wet areas on the floor surface. These
areas can cause a dangerous condition
for the operator or other persons. Always
put CAUTION signs near the area you are
cleaning.
WARNING:
Machines can ignite flammable materials
and vapors. Do not use with or near
flammables such as gasoline, grain
dust, solvents, and thinners. Only use a
cleaning concentration recommended by
the chemical manufacturer.
WARNING:
Clarke recommends a maximum water
temperature of 120°F(49°C)
4. Replace the solution tank lid.
How To Clean A Floor
NOTE: Put the machine in the slow traverse speed. Use the
machine in an area that has no furniture and objects until you
can do the following:
1.
Move the machine in a straight direction, forward and back-
ward.
2.
Stop the machine safely.
3.
Move the machine in a straight direction after you turn the
machine.
To move the machine, follow this procedure:
1.
Turn the key switch “ON” position.
2.
Put the brush switch in the "UP" position.
3. Raise the squeegee.
4. To go forward, push the control handles toward the
machine. See figure #21.
5. To stop the machine, put the handles in the center
position.
6. To go backward, pull the handles away from the ma-
chine. See figure #22.
7. To turn the machine, push the rear of the machine to the
side.
8. When you stop the machine, turn the key switch "OFF".
HOW TO OPERATE THE MACHINE (cont.)
Figure # 19
Figure # 20
Figure # 21
Figure # 22
