9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
FITTING THE TOOL SUPPORT
1. Insert the tool support into the two
mounting holes at the top of the
grinder as shown.
• The tool support can be used to
support the grinding jigs/
clamps, a trueing or dressing
tool, or as a tool or hand rest
when working without jigs.
VERTICAL GRINDING/HONING
1. Adjust the tool support to the desired height, before tightening the two
knobs to secure it in position.
HORIZONTAL GRINDING
1. Attach the tool support by
inserting into the two mounting
holes located on the rear of the
grinder. Adjust to the desired
height, before tightening the two
knobs to secure it as shown.
2. Plug the machine into the nearest
power supply.
3. Attach the water trough beneath
the grinding stone. Fill the water
trough with clean water up to the
cut-out on the trough.
• The grinding stone must run in
water at all times during
operation and will become
soaked with water.
4. Ensure the water trough is re-filled
when necessary and discard any
excess particles of stone which have accumulated in the water trough
after extensive use.
• Avoid pouring the residue down a sink as this mass could eventually
cause a blockage in the household plumbing.
Summary of Contents for CWS200B
Page 20: ......