15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ET154
½
Carat Diamond Tip Wheel Dresser - part No:1700329
1. If the grinding stone is new, allow it to spin for a minute with no load. Check
that it is spinning straight and true. If not, it will require dressing before use.
2. Stand to the side of the stone and hold the dresser handle firmly. Place the
dresser on the tool support so that its wheels can move freely (i.e, the
exposed part of the wheel should be facing up). Run the stone and apply
the dresser to the surface of the stone.
INSTALLING A NEW HONING WHEEL
1. Unscrew and remove the hand
nut and washer that secures the
honing wheel in place.
2. Remove the old honing wheel and
fit the replacement, securing it
with the hand nut and washer.
Ensure the drive pin, rests in the
groove in the hidden face of the
honing wheel.
CLEANING & STORAGE
Clean the exterior the machine if required using a mild detergent or mild
solvent. Never immerse the machine in water.
To reduce any fire hazard, keep the cooling vents below the grinder free of
debris.
If not bolted to a workbench, store the grinder in a clean, dry location, out of
reach of children.
Summary of Contents for CWS200B
Page 20: ......