6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Never use damaged or incorrect grindstones. The stone and retaining
fixtures were specially designed for your grinder, for optimum performance
and safety of operation. Inspect the condition of the grinding stone before
use and do not use if any damage is found.
5. Always use the tool rests to steady the workpiece. If the tool attachments
are not used, the torque of the spinning grinding/polishing wheel may pull
the workpiece from your hands.
6. Never leave the sharpener unattended when it is connected to an
electrical power supply. Switch off the machine and unplug it before
leaving.
7. ALWAYS check for damaged parts. Before further use any part that is
damaged should be carefully checked to determine if it would operate
properly and perform its intended function. Check for misalignment or
binding of moving parts, breakage of parts and any other condition that
may affect the tool's operation. A part that is damaged should be properly
repaired or replaced at an authorised service center. Following this rule will
reduce the risk of electric shock, fire or serious injury.
NOTE:
Bench grinders/sharpeners used in industrial environments may
be subject to the requirements of The Provision and Use of Work
Equipment regulations 1992 (particularly regarding the training
requirement of The Abrasive Wheels Regulations 1970), or other
legislation. If in doubt seek advice.
Please keep these instructions in a safe place for future reference.
SAFETY SYMBOLS
The meanings of the markings and symbols on the product are shown below
Read this manual
before use and keep
in a safe place for
future reference
Wear eye protection
when using this
sharpener.
Gloves should be
worn when grinding.
Wear dust mask when
using the sharpener or
honing wheel.
Summary of Contents for CWS200B
Page 20: ......