22
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Undo the blade retaining nut
using the flange key and
hexagonal key together.
4. Take off the outer flange and
remove the old saw blade.
• Replacement blades are
available from our parts
department (part number
YBTS250E072
).
5. Clean the blade flanges
thoroughly before fitting the new blade.
6. Mount and fasten the new blade in reverse order.
IMPORTANT: Note the running direction. The cutting angle of the teeth must
point in the running direction, i.e. forwards (see the arrow on the blade
guard).
7. Loosen the bolts that hold the
riving knife and adjust the riving
knife position until the distance
between the blade and the riving
knife is between 3-5 mm.
8. Retighten the bolts.
9. Replace the table insert.
10. Replace the saw blade guard.
11. Check to make sure that all
components are properly mounted and in good working condition before
you begin working with the saw again.
WARNING: RESET THE RIVING KNIFE EACH TIME THE SAW BLADE IS
REPLACED (STEP 7 ABOVE).
