12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ATTACH THE TABLE SAW TO THE STAND
1. With assistance, place the table
saw onto the completed stand
and secure from below using the
8 bolts (with integral washers)
supplied.
2. Tighten all the bolts on the stand
securely.
NOTE:
MAKE SURE ALL FIXINGS ARE
SECURELY TIGHTENED AND THE
TABLE SAW IS COMPLETELY
STABLE AND SECURE BEFORE USE.
FIT THE EXTENSION TABLES
1. Loosen the bolts shown on the
rear of the table saw.
2. Slide the rear extension table over
the bolts.
3. Retighten the bolts.
4. Fit the two smaller braces as
shown.
• When fitting, make sure that
the end of the brace is fitted
behind the lip on the extension
table.
5. The two side extensions are fitted
in the same way.
