11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
• Unpack and check for damage which may have occurred in transit.
ASSEMBLE THE STAND AND MOUNT THE TABLE SAW
1. The following parts make up the
stand.
• 2 x Cross member (A)
• 2 x Cross member (a)
• 2 x Cross member (B)
• 2 x Cross member (b)
• 2 x Front Legs
• 2 x Rear Legs
• 2 x Rear Stabilisers
• 4 x Rubber Feet
2. Make up two side frames as
shown.
• The rear legs have holes pre-
drilled for the rear stabiliser.
• Secure using the bolts, washers,
spring washers and nuts
provided (hand tight only at
this stage).
3. Fit the rubber feet.
4. Join the two frames together
using the cross members (A + a)
shown.
• Secure using the bolts, washers,
spring washers and nuts
provided (hand tight only at
this stage).
