12
ASSEMBLY
IMPORTANT:
Take great care to avoid contact with the saw teeth which are extremely sharp
when performing the following operations.
Handle
1.
Attach the handle to the blade angle adjuster as
shown.
2.
Use the screw to secure the handle to the shaft.
Table Extensions
1.
Lower the blade as far as possible.
2.
Carefully turn over the table saw so that it rests on
its table and remove the bottom grille.
3.
Attach 2 short extension support struts, to each
side with a single M6x15 bolt, using a flat and
spring washer on the inside.
DO NOT tighten at this stage.
4.
Attach each Table Extension, noting that they
are ‘handed’ i.e. left hand and right hand, due to
the positioning of the support strut securing holes.
5.
Secure each extension to the table with bolts with
washers, taking great care NOT to cross thread
the bolts.
Attach the support struts to each extension. Tighten the nuts whilst pushing down on the extension,
to ensure it lies flat and level with the table.
6.
Repeat the process using the 2 long extension support struts and the rear table extension.
7.
Replace the bottom grille and, with assistance, turn the table saw on to its base.
NOTE: If the optional stand is to be used, the saw should be bolted to it at this stage.
Fig. 3
Fig. 4
