8
MAINTENANCE
REPLACING THE NOZZLE
After 10-12 hours of blasting time the nozzle should be checked for wear. The
nozzle will wear out overtime and should be replaced when the hole is no longer
round or the abrasive media does not flow smoothly through it. To replace the
nozzle:
1. Disconnect the sandblasting gun from the air hose.
2.
Nozzle
Unscrew the nozzle adaptor,
located at the front of the
sandblasting gun.
3. Remove the old nozzle.
4. Insert new nozzle.
• Replacement nozzles are
available from your Clarke
dealer Part number 7640122
5. Replace the nozzle adapter and
firmly screw it onto sandblasting gun.
• Keep your sandblaster clean and protect it from damage.
• Check for worn abrasive hose and fittings. Watch for leaks, blistering,
bulging or thinning of the hose.
• Replace any parts which appear worn.
PARTS AND SERVICING
For Parts & Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
