7
OPERATION
USING YOUR SANDBLASTER
Connect your sandblasting gun to a compressor (minimum 3hp capable of
supplying a minimum of 10 CFM of air) via the 3/8” hose adaptor located at
the base of the handle.
Set the working pressure on your air compressor to 6 - 8 bar (87 - 116 psi).
1. Connect an air hose (sold
separately) from your compressor,
to the hose fitting on the
sandblasting gun.
2. Make sure air hole located on the
base of the abrasive tank is not
covered.
3. Place the mesh filter on top of the
drum and pour the blasting
medium through the filter into the
drum.
4. Start compressor according to the
manufacturers instructions.
5. Check for leaks along all hoses
and fittings. if leaks are found, turn off the compressor, disconnect the hose
and repair immediately.
6. Point the sandblasting gun in a safe direction away from people, pets or
anything around you that may be damaged by direct or indirect abrasive
spray.
7. Press and hold the sandblasting gun trigger until abrasive medium is flowing
through the nozzle.
TO STOP BLASTING
1. Release the trigger on the sandblasting gun.
