12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Place the grinding disc over the spindle and on top of the inner flange.
• If the grinding wheel supplied is a depressed centre type, mount it as
shown, i.e.with the depressed centre (printed side) towards the
machine.
• For standard discs make sure that the raised section of the outer
flange is pointing towards the disc.
5. Screw on the outer flange with the centre boss facing inwards so as to sit
inside the aperture of the disc. Tighten securely with the pin spanner.
• When using thin discs, the outer flange washer can be reversed so
that the raised section is pointing away from the disc.
6. Press and hold the spindle lock and use the pin spanner to tighten the
outer flange. Care should be taken also NOT to overtighten the outer
flange.
FITTING THE SIDE HANDLE
1. Fit the side handle by screwing it
into the threaded hole on either
the left or right hand side of the
angle grinder.
Summary of Contents for CONTRACTOR CON1050B
Page 20: ......
