18.
Male Bolt Recesses (Fig. 11)
-
Place the worktop with laminate face down.
19.
Fully insert 3 pins in the holes marked
‘CB’.
20.
Clamp the jig to the worktop ensuring all 3 pins are pushed firmly against the
worktop. Ensure clamps do not obstruct the router path.
Male bolt recesses -
Laminate face down.
Fig. 11
21.
Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again, increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
22.
Repeat step
21
for the other 2 recesses (other 3 recesses for 900mm worktops).
IMPORTANT
Recesses must be no deeper than 20mm maximum.
Cutting To Length
Fig. 12
-10-
When producing a male joint left or right
hand, the position of the jig has to be
calculated. It is easier if the female joint is
cut first, leaving the gap intended for the
male part of the worktop.
Example
The female joint has already been cut
(
Fig. 12
) the length of the male worktop
needed is 1000mm (1metre).
1000mm
Post Form Edge
Summary of Contents for CONTRACTOR 6462118
Page 20: ......
