-4-
Using The Jig
Front View
Rear View
Fig. 1
Fig. 2
Before Starting:
ALWAYS
ensure the worktop is firmly supported on trestles or similar.
ensure the jig is firmly secured to the worktop using no less than 2 quick
woodworking clamps or similar.
ensure there are no obstructions in the path of the router, also the router cutter
beneath the worktop, i.e. the cutter doesn’t cut into the bench/trestle when cutting
through the worktop.
use only good quality sharp tungsten router bits.
cut
into
the post form edge (curved edge) of the worktop to avoid break out or
chipping of the laminate.
keep the router vertical to the jig and laminate.
keep the jig surface clean.
NEVER
exceed 10mm depth of cut in one pass.
remove or position the router whilst the cutter is still rotating.
PLEASE NOTE: for illustrative purposes only, all diagrams and instructions in this manual
make reference to 700mm worktops, but apply equally to all sizes of worktop ranging
from 400mm to 900mm
Summary of Contents for CONTRACTOR 6462118
Page 20: ......
