Clarke CONTRACTOR 6462072, Operation & Maintenance Instructions Manual

Page: 10 / 20

10
FITTING THE TRAMMEL ATTACHMENT
1. Remove one of the rods from the parallel guide and insert it into position on
the router. Secure in place using the parallel guide locking screws.
2. Loosen the wing nut on the
trammel attachment and slide
the attachment on to the parallel
guide rod as shown.
3. Adjust the height of the pivot
point by turning the screw.
4. Tighten the wing nut to lock the
pivot point in place and the
trammel attachment to the rod.
USING YOUR ROUTER
When using the router, there are some points to bear in mind which will ensure
that the best results are achieved.
SWITCHING THE ROUTER ON/OFF
1. Grip the tool with both hands,
ensuring the power on/off switch
is in the right hand.
2. Push and hold the safety button,
and pull the trigger switch.
• Allow the motor to reach full
speed before use.
3. To stop the router, simply release
the trigger.
TO PLUNGE THE ROUTER
1. Place router on the workpiece with the cutter in the position to be cut.
Screw
Wing Nut
Piviot Point
Rod