15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PERFORMING A SLIDING CUT
The guide rail allows cutting larger workpieces up to 340 mm x 78 mm using an
out-down-back sliding motion.
1. Release the slide rail lock.
2. Pull the saw head towards you (1)
and switch the saw on as
mentioned on the previous page.
3. Lower the saw blade (2) into the
workpiece and push the head
back (3) to complete the cut.
• Do not perform sliding cuts on
workpieces smaller than 50 x
100 mm.
• Remember to lock the saw
head in the rear position when
the sliding cuts are finished.
MITRE CROSS-CUT
1. Release the table mitre lock and
move the arm left or right to the
required angle.
2. Lock in position by tightening the
table mitre lock.
• Always ensure that the table
mitre lock is securely tightened
before cutting.
• Allow the blade to cut freely.
Do not force the tool.
• Proceed as for a vertical straight cross-cut.
NOTE:
When mitering the end of a piece of wood with a small off-cut, position
the wood to ensure that the off-cut is to the side of the blade with the
greater angle to the fence; i.e. left mitre, offcut to the right - right mitre,
off-cut to the left.
Summary of Contents for CMS10S2
Page 28: ......
