9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
JUMP STARTING
CONNECTING THE SMART CABLE TO THE POWER PACK
1. Lift the rubber plug and insert the
jumpstart leads into the power
pack.
• The red & green LEDs will flash
alternatively.
CONNECT THE JUMP START LEADS TO THE BATTERY
1. Connect the red clamp to the unearthed battery terminal first, (this is
usually the positive (+ve) terminal and painted RED).
2. Connect the black clamp to the earthed battery terminal, (this is usually
the negative (-ve) terminal and painted BLACK)
• LED show solid green: Reasdy to start
• LED flashes red and green: Means the smart cable is in search mode,
to activate turn the ignition on (ACC)
• LED shows solid red: indicates a failed connection, possible faults
are:
WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE
DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE VEHICLE
HANDBOOK TO DETERMINE IF ANY PRECAUTIONS SHOULD BE TAKEN.
Jump starter does not
have enough power
Check the power level of the jump starter and
charge if required.
Short Circuit
Make sure that the positive & negative leads are
not touching, remove them & restart.
Reverse Polarity
Make sure that the smart cable clamps are
connected correctly to the car battery, remove
them & restart.
Over Heating
Wait for a few minutes & try again.
Summary of Contents for CLIPPJS
Page 12: ......
