12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATING INSTRUCTIONS
STARTING THE COMPRESSOR
1. Pull the ON/OFF switch shown in
Fig 5, upwards to start the
compressor. The motor should
start immediately and run while
the reservoir is being pressurised.
2. When starting the compressor for
the first time and before
connecting it to the airline
equipment, leave it running for
about 10 minutes to permit a
good distribution of lubricating oil.
3. Check the operation of the safety valve under pressure on a daily basis by
pulling the ring shown above. Air should be released while the ring is pulled
and stop when the ring is released.
•
If the valve does not operate as described, or is stuck, it must be replaced
by your Clarke dealer before the compressor is used.
•
Observe that the compressor stops automatically when the maximum
pressure of 10 bar is reached. The pressure is indicated on the reservoir
pressure gauge shown below.
WARNING: NEVER REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.
Summary of Contents for CHAMP
Page 24: ......
