9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FITTING THE HANDLE
The CAT123 is supplied with a
removable side handle. To install it
proceed as follows.
1. Slide the clamping ring over the
body of the drill.
2. Screw the handle onto the
threaded part of the clamping ring
until the handle assembly is tight.
The handle can be located at any
position around the drill by loosening
the handle grip and re-tightening to secure in position.
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by inserting
the chuck key in one of the holes
in the chuck and turning it as
shown.
2. Make sure that the head of the
chuck key is located on the barrel
of the chuck.
3. Turn the chuck key until the chuck
jaws are open sufficiently to take
the drill bit.
4. Place the drill bit in the jaws of the
chuck as far as it will go.
5. Close the chuck jaws and tighten
to grip the drill bit by turning the
chuck key as shown.
6. Make sure that the chuck jaws are
fully closed and that the drill bit is
held firmly.
7. Your air drill is now ready for use.
Drill bit
Chuck jaws
Close
Open
Chuck
key
jaws
jaws
Barrel
Summary of Contents for CAT123
Page 16: ......
