8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE FORCE
Chisel force may be adjusted by
turning the speed controler/air
regulator knob, located at the base
of the handle grip.
• Turn anticlockwise to increase
force.
• Turn clockwise to reduce.the
force.
USING THE AIR HAMMER
1. Hold the tool with one hand
around the handle and one hand
around the barrel, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Pull the trigger with the chisel in
light contact with the work.
3. Move slowly across the work
surface and proceed to remove
scale, rust or other contaminants, a light force only should be required.
4. Release the trigger to stop operation, whilst maintaining contact with the
work, noting that the tool may impact briefly after the trigger is released.
NOTE:
The Retaining Spring has a life expectancy, depending upon the
intensity of usage. It is strongly recommended that you procure
one or two spare springs, for use in the event of failure occurring
during the course of a particular job.
DISCONNECTING THE AIR SUPPLY
Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
1. Refer to the compressor instruction book for the procedures to shut down
and release the compressed air.
2. Once the pressure has been released, disconnect the air supply hose from
the tool.
3. Store the tool safely in its box in a dry, secure environment.
Summary of Contents for CAT114
Page 16: ......
