Clarke BOXER 55, Operating & Maintenance Manual

Page: 15 / 28

1 5
OPERA OPERA
OPERA OPERA OPERATING INSTRUCTIONS
TING INSTRUCTIONS
TING INSTRUCTIONS TING INSTRUCTIONS TING INSTRUCTIONS
Switching the air compressor ON Switching the air compressor ON Switching the air compressor ON Switching the air compressor ON Switching the air compressor ON
The compressor will mak The compressor will mak
The compressor will mak The compressor will mak The compressor will make a continuous loud noise when the tank is charging -
e a continuous loud noise when the tank is charging -
e a continuous loud noise when the tank is charging - e a continuous loud noise when the tank is charging - e a continuous loud noise when the tank is charging -
this is normal this is normal this is normal this is normal this is normal.....
1 Lift the red On/Off switch located on top of the pressure regulator to switch
the compressor ON.
• The compressor will then charge the main tank to 10 bar (145 psi). When
this pressure is reached, the compressor will switch off.
• The compressor will restart automatically whenever the pressure in the
main tank falls below a certain level.
2 Check the operation of the safety
valve, under pressure, daily by pulling
the ring as shown in figure 7. Air should
be released you pull the ring and stop
when the ring is released.
• If the valve does not operate as
described, or if the valve is stuck, it
must be replaced by qualified
service personnel before using the
compressor.
W W W W WARNING! ARNING! ARNING! ARNING! ARNING!
Do not r Do not r Do not r Do not r Do not remove or attempt to adjust the safety valve. emove or attempt to adjust the safety valve. emove or attempt to adjust the safety valve. emove or attempt to adjust the safety valve. emove or attempt to adjust the safety valve.
3 Loosen the locking ring and select the
pressure you need using the pressure
regulator.
4 Tighten the locking ring by holding the
pressure regulator firmly in place and
rotating the locking ring anticlockwise
until it tightens against the underside
of the pressure regulator. See figure 8.
• This will prevent you from
accidentally increasing the
pressure to a dangerous level.
Figure 8
Figure 7
Pressure
regulator
Locking ring
Output pressure
gauge