9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE PUMP
1. Plug in the pump and switch on the power supply.
• The pump will begin to drain water.
2. Run the pump continuously or remove from the water and store in a frost
free location if the water is likely to freeze.
3. Never run the pump dry. Ensure the pump is switched off when water has
stopped flowing.
• The pump should be able to clear water down to a residual depth of
the inlet port, In this situation, air and residual water may be seen
escaping from the discharge hose.
4. Disconnect from the power supply when the water has been pumped out.
Avoid running the pump continuously if the discharge hose has become
obstructed and water is not flowing.
OVERLOAD PROTECTION
These pumps are fitted with automatic thermal overload protection.
If the pump overheats due to an obstruction in the pump, or pumping warm
water for example, it will shut off automatically.
Switch the pump OFF at the mains supply. Check for blockages and allow the
motor to cool (at least 5 minutes) by which time the cut-out will have reset.
Once the pump has cooled the pump will automatically restart.
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
Summary of Contents for 7230296
Page 16: ......